How to Reduce the Probability of Failure of Electric Cigarettes?
- Share
- Issue Time
- Nov 29,2021
Summary
As long as the electric cigarette is operated and maintained correctly, equipment failures can be avoided to a large extent. Today, let’s talk about the method to reduce the probability of e-cigarette failure.
E-cigarettes usually fail because of improper operation during normal use and maintenance. Therefore, whether you are a new user or an e-cigarette enthusiast, you must consider the following aspects in use and maintenance.
1. Place
E-cigarettes should be placed according to a principle. When there is e-liquid in the atomizer, the cigarette holder should be placed upwards. But it is better not to stand upside down to prevent the remaining smoke oil in the atomizer from being exposed.
2. Battery maintenance
The maintenance of the battery is more important because the e-cigarette battery is a main component. Try to charge the battery after it is used up. Charge it once and do not cut off the power halfway.
Remove the battery within half an hour after it is fully charged, and turn off the power of the e-cigarette when it is not used for a long time. Generally, e-cigarettes are switched on and off 5 times within 2 seconds.
When the e-cigarette is not in use, the battery should be taken out into the VC4S charger and used in the storage mode to charge and discharge the battery to 3.7V for low-temperature dry storage.
3. Atomizer
The core of the atomizer is the atomizing core, which is composed of a resistor, an oil guide rope, and some accessories. The most common problem with the atomizer is that the atomizer produces a burnt smell. The reason is that the resistance heating causes the wick to burn. Therefore, during use, pay attention to the remaining amount of e-liquid, and do not dry it. The adjustable voltage engine room should adjust the voltage appropriately.
Don't pursue high voltage. It's good to have a suitable taste. If you want to smoke, you must pay attention to the e-liquid. Generally, when the remaining e-liquid is more than 2/3, it is not easy to cause burn when using 5-6V voltage. Paste smell slowly lowers the voltage as the e-liquid decreases.
4. Some treatments for oil leakage and oil in the atomizer
Conventional atomizers generally have an air guide hole at the bottom to guide air. But after a long time, there will be a little smoke oil (but it will not leak to the fuselage, and it will not be felt outside), this is normal.
It is recommended to separate the battery and the atomizer every time you add the smoke oil and wipe it with a paper towel. Because usually add smoke oil about once a day, rub it once a day.
The atomizer has oil, there are two main situations:
(1) There is oil in the place where the cigarette holder is in contact with the mouth, which may be caused by adding oil to the cigarette outlet by mistake, just wipe it with a paper towel;
(2) The smoke has oil but there is no oil in the cigarette holder. There is oil in the smoke outlet. Wipe down the atomizing core and use a paper towel to rub it into thin strips and extend into the smoke outlet to absorb the smoke oil.
JOCEIG, as an expert in e-cigarette research for many years, can give you some suggestions to a certain extent. If you want to know more about e-cigarettes after reading the above, you can get a comprehensive solution by contacting us.
JOCEIG is an experienced e-cigarette manufacturer, and our aim is to put the needs of customers first. We have a professional production team and a strict quality inspection system, which can control the quality of our products in an all-round way. Our products are sold worldwide and have received a lot of praise and trust from users. If you are interested in our e-cigarettes, please contact us immediately!